Abstract The present investigation mainly addresses the open circuit voltage (Voc) issue in kesterites based Cu2ZnSn(S,Se)4 solar cells by simply introducing alkali metal fluoride nanolayers (  several nm NaF, or LiF) to lower the work functions of the front İTO\} contacts without conventional hole-blocking ZnO layers. Kelvin probe measurements confirmed that the work function of the front İTO\} decreases from 4.82 to 3.39 and 3.65 eV for NaF and LiF, respectively, resulting in beneficial band alignment for electron collection and/or hole blocking on top electrodes. Moreover, a 10.4% power conversion efficiency ( 11.5% in the cell effective area) \{CZTSSe\} cell with improved Voc of up to 90 mV has been attained. This demonstration may provide a new direction of further boosting the performance of copper chalcogenide based solar cells as well.

In this study, we developed highly dispersed rhenium nanoparticles decorated on activated carbon (Re@CDACs). The activated carbons were derived from the biomass raw materials cardamom pods (Elettaria cardamomum L) via carbonization followed by activation with ZnCl2 at high temperature. The Re NPs synthesis was achieved by decomposition of [Re2(CO)10] complex via a facile microwave thermal reduction technique. The as-prepared Re@CDACs nanocomposites were characterized by a combination of state-of-the-art techniques. The Re@CDACs nanocomposites so prepared were utilized for electrocatalytic oxidation of sunset yellow (SY) and supercapacitor applications. The Re@CDACs-modified electrodes were found to show extraordinary electrochemical performance for sensitive and selective detection of SY with a wide linear range of 0.05–390 μM and a detection limit and sensitivity of 16 nM (S/N = 3) and 91.53 μA μM−1, respectively, surpassing other modified electrodes. Moreover, these Re@CDACs catalysts were also found to exhibit a higher specific capacitance of 181 F g-1 at a current density of 1.6 A g−1 in 1.0 M H2SO4 electrolyte. The specific capacitance retention of 90% was achieved after 2500 cycles at current density 2.0 A g−1. Therefore, we have demonstrated that the Re@CDACs nanocomposite materials could be used as a promising electrode material in electrochemical oxidation of SY and energy storage applications. © 2018

Polyethersulfone ionomers containing quaternary ammoniums were prepared for the applications on alkaline anion exchange membrane (AAEM) fuel cells. The ionomers were synthesized from 2,2′-dimethyl-4,4′-biphenyldiol and bis(4-chlorophenyl) sulfone via nucleophilic substitution followed by bromination, quaternization and anion exchange reaction. The biphenyl structure in polymer main chain exhibited atropisomerism after bromination, leading to the anisochronous signals of geminal protons on bromomethyl groups in 1H NMR spectra. Model compounds were synthesized to confirm the atropisomerism by EI mass and 1H NMR spectra. The resonance peaks from five possible repeating units of brominated polyethersulfones in the 1H NMR spectra were identified and discussed in detail. The rotational barriers of biphenyl structures containing brominated methyl groups at 2 and 2′ positions were calculated by density functional theory. The properties of these polyethersulfone anion exchange membranes (AEMs) were characterized. Their IECs ranged from 0.81 to 1.75 mequiv/g. The corresponding water uptakes and dimensional changes were in the ranges of 19–42% and 12–38%, respectively. The tensile strength of an AEM (1.75MQAPES-OH) with an IEC of 1.75 mequiv/g remained 17 MPa even though the water uptake was 42%. The hydroxide conductivity of 1.75MQAPES-OH could reach 51.4 mS/cm at 98%RH and 80 °C. After alkaline stability test for 168 h, the AEMs degraded slightly in terms of their IECs and hydroxide conductivity.

One of the key challenges in artificial photosynthesis is to design a photocatalyst that can bind and activate the CO2 molecule with the smallest possible activation energy and produce selective hydrocarbon products. In this contribution, a combined experimental and computational study on Ni-nanocluster loaded black TiO2 (Ni/TiO2[Vo]) with built-in dual active sites for selective photocatalytic CO2 conversion is reported. The findings reveal that the synergistic effects of deliberately induced Ni nanoclusters and oxygen vacancies provide (1) energetically stable CO2 binding sites with the lowest activation energy (0.08 eV), (2) highly reactive sites, (3) a fast electron transfer pathway, and (4) enhanced light harvesting by lowering the bandgap. The Ni/TiO2[Vo] photocatalyst has demonstrated highly selective and enhanced photocatalytic activity of more than 18 times higher solar fuel production than the commercial TiO2 (P-25). An insight into the mechanisms of interfacial charge transfer and product formation is explored.

A new reaction scheme is proposed to account for roaming and chaotic behaviors in collisional and photo-initiated molecular-beam reactions, where nonadiabatic dynamics plays a key role and the collapse of superposition of wave functions is considered to be important in the beginning of the present scheme. Since the feature of molecular orbitals of reagents is crucial in reaction, we showed how to map out the spatial distribution of the relevant HOMO molecular orbitals of CH3Cl in the impact of fast electrons. We identified by experiment that the multiple overlap of nearby molecular orbitals affects even the vibrational motion of adjacent molecule DCl of the transient [ClDCl] chemical species. We also showed dynamical steric effects in the HBr + OH four-atom reaction as a manifestation of the nonadiabatic dynamics in complex systems. The roaming mechanism in the photo-initiated reaction of methyl formate is clarified in detail by experiment as well as the QCT trajectory calculation, where the conical intersection region plays an essential role. We suggest that two types of roaming trajectories coexist, i.e., deterministic and chaotic roaming trajectories based on classical trajectory calculations. To clarify the nonadiabatic dynamics in the roaming mechanism for non-collinear three-dimensional (3D) collisions, a new model of the 3D Polanyi rule is proposed as the extension of the well-established 2D Polanyi rule. In the 3D Polanyi rule, it is expected that the curvature and torsion of Frenet–Serret formulas in three-dimensional space would provide us key concepts in understanding reaction dynamics. © 2018, Accademia Nazionale dei Lincei.

An alternative to the transition state (TS) pathway, the roaming route, which bypasses the minimum energy path but produces the same molecular products, was recently found in photodissociation dynamics. This account describes signatures of roaming in photodissociation of the carbonyl compounds, specifically methyl formate and aliphatic aldehydes. Methyl formate was promoted to the excited state, followed by internal conversion via a conical intersection. Then, the energetic precursor dissociated to fragments which proceeded along either TS or roaming path. In contrast to the lack of a roaming saddle point found in methyl formate, the structure of the roaming saddle point for each of a series of aliphatic aldehydes comprises two moieties that are weakly bound at a distance. As its size increases, the energy difference between the TS barrier and the roaming saddle point increases and the roaming pathway becomes increasingly dominant. Experimentally, the rotational-level dependence of the roaming route was measured with ion imaging, while the vibrational-state dependence was observed with time-resolved Fourier-transform infrared emission spectroscopy. The roaming signature was verified theoretically by quasi-classical trajectory (QCT) calculations. As an alternative to the QCT method, a multi-center impulsive model was developed to simulate the roaming scalar and vector properties. © 2018 Informa UK Limited, trading as Taylor & Francis Group.

In this work, we describe a facile fabrication of silver nanoparticles decorated on porous ultrathin two dimensional (2D) graphitic carbon nitride nanosheets (AgNPs@g-CN) via chemical approach, which was characterized by various analytical techniques including cyclic voltammetry (CV), differential pulse voltammetry (DPV) and chronoamperometry. As expected, the AgNPs@g-CN modified glassy carbon electrode (AgNPs@g-CN/GCE) exhibited remarkable electrocatalytic activity towards the detection of quercetin (QCR) with a wide linear range from 1.0 × 10−8 to 1.2 × 10−4 mol L−1 and a lower detection limit of 6.0 × 10−9 mol L−1. Besides, the amperometric results revealed that the peak current for QCR could not affect upon the sequential additions of electroactive interfering species such as metal ions (300 μM), biomolecules (100 μM), and other flavonoids (50 μM) indicating the selectivity of the proposed sensor. Moreover, the AgNPs@g-CN modified electrode displayed higher stability and reproducibility towards the detection of QCR. The AgNPs@g-CN/GCE could also be used to detect QCR in green apple (GA) samples with satisfactory recoveries for practical applications. The concepts behind the novel architecture to modify electrodes can be potentially harnessed in other electrochemical sensors and photocatalysis applications. © 2018 Elsevier B.V.

n/a

Production of hydrogen from water electrolysis has stimulated the search of sustainable electrocatalysts as possible alternatives. Recently, cobalt phosphide (CoP) and molybdenum phosphide (MoP) received great attention owing to their superior catalytic activity and stability towards the hydrogen evolution reaction (HER) which rivals platinum catalysts. In this study, we synthesize and study a series of catalysts based on hybrids of CoP and MoP with different Co/Mo ratio. The HER activity shows a volcano shape and reaches a maximum for Co/Mo = 1. Tafel analysis indicates a change in the dominating step of Volmer-Hyrovský mechanism. Interestingly, X-ray diffraction patterns confirmed a major ternary interstitial hexagonal CoMoP(2) crystal phase is formed which enhances the electrochemical activity.

Two-dimensional materials constitute a promising platform for developing nanoscale devices and systems. Their physical properties can be very different from those of the corresponding three-dimensional materials because of extreme quantum confinement and dimensional reduction. Here we report a study of TiTe2 from the single-layer to the bulk limit. Using angle-resolved photoemission spectroscopy and scanning tunneling microscopy and spectroscopy, we observed the emergence of a (2 × 2) charge density wave order in single-layer TiTe2 with a transition temperature of 92 ± 3 K. Also observed was a pseudogap of about 28 meV at the Fermi level at 4.2 K. Surprisingly, no charge density wave transitions were observed in two-layer and multi-layer TiTe2, despite the quasi-two-dimensional nature of the material in the bulk. The unique charge density wave phenomenon in the single layer raises intriguing questions that challenge the prevailing thinking about the mechanisms of charge density wave formation.