Photolysis Dynamics Laser Chemistry Lab

Ab initio potential energy surfaces and the corresponding analytical energy functions of the ground 1A′ and excited 2A′ states for the Li(22P) plus H2 reaction are constructed. Quasiclassical trajectory calculations on the fitted energy functions are performed to characterize the reactions of Li(22P) with H2(v 0, j 1) and H2(v 1, j 1) as well as the reaction when the vibrational energy is replaced by collision energy. For simplicity, the transition probability is assumed to be unity when the trajectories go through the crossing seam region and change to the lower surface. The calculated rotational distributions of LiH(v 0) for both H2(v 0, j 1) and H2(v 1, j 1) reactions are single-peaked with the maximum population at j′ 7, consistent with the previous observation. The vibrational excitation of H2(v 1) may enhance the reaction cross section of LiH(v′ 0) by about 200 times, as compared to a result of 93-107 reported in the experimental measurements. In contrast, the enhancement is 3.1, if the same amount of energy is deposited in the translational states. This endothermic reaction can be considered as an analog of late barrier. According to the trajectory analysis, the vibrational excitation enlarges the H-H distance in the entrance channel to facilitate the reaction, but the excess energy may not open up additional reaction configuration. © 2011 American Institute of Physics.

Competitive bond dissociation mechanisms for bromoacetyl chloride and 2- and 3-bromopropionyl chloride following the 1[n(O) →π*(Cï£O)] transition at 234-235 nm are investigated. Branching ratios for C-Br/C-Cl bond fission are found by using the (2+1) resonance-enhanced multiphoton ionization (REMPI) technique coupled with velocity ion imaging. The fragment branching ratios depend mainly on the dissociation pathways and the distances between the orbitals of Br and the Cï£O chromophore. C-Cl bond fission is anticipated to follow an adiabatic potential surface for a strong diabatic coupling between the n(O)π*(Cï£O) and np(Cl)σ*(C-Cl) bands. In contrast, C-Br bond fission is subject to much weaker coupling between n(O)π*(Cï£O) and np(Br)σ*(C-Br). Thus, a diabatic pathway is preferred for bromoacetyl chloride and 2-bromopropionyl chloride, which leads to excited-state products. For 3-bromopropionyl chloride, the available energy is not high enough to reach the excited-state products such that C-Br bond fission must proceed through an adiabatic pathway with severe suppression by nonadiabatic coupling. The fragment translational energies and anisotropy parameters for the three molecules are also analyzed and appropriately interpreted. Busted open: Insight into the mechanisms causing C-Cl and C-Br bond fission of bromoacetyl chloride and 2- and 3-bromopropionyl chloride by following the 1[n(O) →π*(Cï£O)] transition is obtained. The figure shows the center-of-mass translational energy distributions of ground-state Br formation through a diabatic pathway for the dissociation of 2-bromopropionyl chloride. Copyright © 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Upon one-photon excitation at 248 nm, gaseous CH3C(O)SH is dissociated following three pathways with the products of (1) OCS + CH 4, (2) CH3SH + CO, and (3) CH2CO + H 2S that are detected using time-resolved Fourier-transform infrared emission spectroscopy. The excited state 1(nO, π *CO) has a radiative lifetime of 249 ± 11 ns long enough to allow for Ar collisions that induce internal conversion and enhance the fragment yields. The rate constant of collision-induced internal conversion is estimated to be 1.1 × 10-10 cm3 molecule -1 s-1. Among the primary dissociation products, a fraction of the CH2CO moiety may undergo further decomposition to CH2 + CO, of which CH2 is confirmed by reaction with O2 producing CO2, CO, OH, and H2CO. Such a secondary decomposition was not observed previously in the Ar matrix-isolated experiments. The high-resolution spectra of CO are analyzed to determine the ro-vibrational energy deposition of 8.7 ± 0.7 kcal/mol, while the remaining primary products with smaller rotational constants are recognized but cannot be spectrally resolved. The CO fragment detected is mainly ascribed to the primary production. A prior distribution method is applied to predict the vibrational distribution of CO that is consistent with the experimental findings. © 2013 American Institute of Physics.

Cavity ring-down absorption spectroscopy (CRDS) is employed to investigate one-photon dissociation of (COCl)2 at 248 nm obtaining a primary Cl2 elimination channel. A ratio of vibrational population is estimated to be 1:(0.12 ± 0.03):(0.011 ± 0.003) for the v = 0, 1, and 2 levels. The quantum yield of Cl2 molecular channel is obtained to be 0.8 ± 0.4 initiated from the X̃ 1Ag ground state surface (COCl)2 via internal conversion. The obtained total quantum yield is attributed to both primary ((COCl)2 + hν → 2CO + Cl2) and secondary reactions (dominated by Cl + COCl → Cl2 + CO). The former is estimated to share a yield of >0.14, while the latter contributes up to 0.66. The photodissociation pathway to the molecular products is calculated to proceed via a four-center transition state (TS) from which Cl2 is eliminated synchronously. Installation of the mirrors with reflectivity of 99.995% in the CRDS apparatus prolongs the ring-down time to 70 μs, thus allowing for the contribution from 17% up to 66% of the total Cl2 yield from secondary reaction depending on the reaction temperature. Despite uncertainty in determining the product yield, the primary Cl2 dissociation channel eliminated from (COCl)2 is observed for the first time. © 2017 American Chemical Society.