Multielement alloying is an appealing approach for suppressing thermal conductivity of thermoelectric materials. In this study, we synthesized GeTe-based high-entropy alloys with notable (S, Se) substitution at Te sites and (Ag, Sb) at Ge sites. The Ge0.82Ag0.08Sb0.1S0.5Se0.1Te0.4 exhibits an extremely low thermal conductivity of ∼ 0.66 W/m⋅K and a high Seebeck coefficient (>250 μV/K) over a temperature range of 150 – 400 °C. The influence of lattice distortion on phase transformation and transport properties of Ge0.9-2xAg2xSb0.1S0.5Se0.1Te0.4 (x = 0 – 0.06) was investigated.

Although hematite (i.e., α-Fe2O3) has been widely investigated in photoelectrochemical water oxidation studies due to its high theoretical photocurrent density, it still suffers from serious surface charge recombination and low photoelectrochemical stability. Here we report an in-situ electrochemical method to form a uniform and ultrathin (i.e., 3–5 nm) passivation layer all over the porosities of the optimized ~3.2% Ti-doped α-Fe2O3 photoanode. We unveil the amorphous and defective nature of the in-situ derived layer assigning to a high concentration of oxygen vacancy and intercalated potassium atoms there, i.e., the formation of Ti/K co-doped defective α-Fe2O3-x. Owing to the efficient passivation of surface states, alleviated surface-potential fluctuations, and low charge-transfer resistance at the interface, photoanodes show an average of ~60% enhancement in the photoelectrochemical performance, applied bias absorbed photon-to-current efficiency of 0.43%, and Faradaic efficiency of ~88%. Moreover, the passivation layer prevents direct contact between the electrode material and electrolyte, resulting in less degradation and outstanding photoelectrochemical stability with photocurrent retention of ~95% after ~100 hours, albeit by performing several successive in-situ electrochemical passivation processes. This work presents an industrially scalable method to controllably engineer the interfaces of semiconductors–electrolytes with precious metal-free defective hematite-based co-catalysts for sustainable photoelectrochemical solar-to-fuel conversion applications.

{Probing and controlling the valley degree of freedom in graphene systems by transport measurements has been a major challenge to fully exploit the unique properties of this two-dimensional material. In this theoretical work, we show that this goal can be achieved by a quantum-wire geometry made of gapped graphene that acts as a valley filter with the following favorable features: (i) all electrical gate control, (ii) electrically switchable valley polarity, (iii) robustness against configuration fluctuation, and (iv) potential for room temperature operation. This valley filtering is accomplished by a combination of gap opening in either bilayer graphene with a vertical electrical field or single layer graphene on h-BN, valley splitting with a horizontal electric field, and intervalley mixing by defect scattering. In addition to functioning as a building block for valleytronics, the proposed configuration makes it possible to convert signals between electrical and valleytronic forms, thus allowing for the integration of electronic and valleytronic components for the realization of electro-valleytronics.}

Abstract Effects of electronic and atomic structures of V-doped 2D layered SnS2 are studied using X-ray spectroscopy for the development of photocatalytic/photovoltaic applications. Extended X-ray absorption fine structure measurements at V K-edge reveal the presence of VO and VS bonds which form the intercalation of tetrahedral OVS sites in the van der Waals (vdW) gap of SnS2 layers. X-ray absorption near-edge structure (XANES) reveals not only valence state of V dopant in SnS2 is ≈4+ but also the charge transfer (CT) from V to ligands, supported by V Lα,β resonant inelastic X-ray scattering. These results suggest V doping produces extra interlayer covalent interactions and additional conducting channels, which increase the electronic conductivity and CT. This gives rapid transport of photo-excited electrons and effective carrier separation in layered SnS2. Additionally, valence-band photoemission spectra and S K-edge XANES indicate that the density of states near/at valence-band maximum is shifted to lower binding energy in V-doped SnS2 compare to pristine SnS2 and exhibits band gap shrinkage. These findings support first-principles density functional theory calculations of the interstitially tetrahedral OVS site intercalated in the vdW gap, highlighting the CT from V to ligands in V-doped SnS2.

n/a

n/a

n/a